Artificial Turf Installation San Diego, California

Artificial Turf Installation Steps

Step 1

Site Preparation

Clear the Area: Remove any existing grass, plants, or debris.
Level the Ground: Ensure the area is flat and even. Fill in any holes or uneven spots.

Step 2

Laying the Base

Apply a Weed Barrier: Lay down a weed barrier fabric to prevent weed growth.
Add Base Material: Spread a layer of crushed stone or gravel. This helps with drainage and provides a stable base.

Step 3

Compacting the Base

Compact the Base: Use a compactor or roller to firm up the base material. This step is crucial for a stable and smooth surface.

Step 4

Installing Edging

Set Up Edging: Install a border or edging material around the perimeter to define the area and contain the turf.

Step 5

Rolling Out the Turf

Unroll the Turf: Carefully roll out the artificial turf over the prepared base. Let it settle for a couple of hours to remove any creases.

Step 6

Trimming and Securing

Trim Excess: Use a sharp knife to trim any excess turf.
Secure the Turf: Fasten the turf down at the edges and any seams using turf pegs or adhesive.

Step 7

Seaming

Join Seams: If you have multiple pieces of turf, join them with seaming tape and adhesive.

Step 8

Adding Infill

Spread Infill: Evenly distribute infill (like sand or rubber crumb) across the turf. This gives it weight, helps it stand up, and improves drainage.
Brush the Turf: Use a stiff brush or broom to work the infill into the base of the turf.

Step 9

Final Touches

Inspect and Clean: Check for any loose edges or imperfections. Clean off any debris.